Operation steps and precautions of the hottest sol
2022-08-20- Detail
Operating steps and precautions of solid-state heat shrinkable packaging machine
operating steps of solid-state heat shrinkable packaging machine:
1. Use two-phase 220V voltage, three pin plug, one of which is the chassis grounding safety wire. Do not connect this wire to 380V voltage
2. Close the side thermal switch (5) and adjust the side thermal knob (13) to about gear 4
close the heat switch (2) and adjust the heat knob (11) to about gear 4
close the lower thermal switch (4) and adjust the lower thermal knob (12) to about gear 4
close the conveying switch (2) and adjust the conveying knob (13) until the mechanical equipment is essentially in the same gear
after the above operations are completed, let the machine run for about 3 minutes
3. The products to be heat shrinkable are placed on the conveyor belt from the inlet of the machine
4. The conveyor belt sends the product into the shrinkage chamber of the machine. After heating, the outer film of the product is heated and compressed
5. Obtain the heat shrinkable products from the outlet of the machine, and check that the outer covering film is not damaged, not tightly wrapped, wrinkled, etc
6. After packaging, turn off three groups of heating switches first, let the conveying motor and hot air motor continue to operate for about 10 minutes, and then cut off the whole 2. Check whether the deformation sensor selection and curve display coordinates of the experimental scheme are accurate
precautions for the use of solid heat shrinkable packaging machine:
1 The machine should be installed horizontally, otherwise the belt is easy to deviate
2. If the machine has been used for more than three months, check the aging of wires in the shrinkage chamber and replace them as appropriate
3. Use two-phase 220V voltage and three pin plug, one of which is the chassis grounding safety wire. Do not connect this wire to 220V voltage
4. In practice, if there are too many wrinkles after shrinkage, the conveying speed can be reduced or the heating temperature can be increased On the contrary, if there is shrinkage and cracking, it can help the transformation and upgrading of the plastic industry and reduce the temperature
- ·Taskforce boss lands in Carnarvon to ramp up Cleo
- ·Ex-employee says she left Rideau Hall after reprim
- ·Scotland’s deficit balloons to 22% of GDP - Today
- ·Candace Barta-Bonk named honorary Hungarian consul
- ·Australian school students have had a tough year,
- ·North-east lifeboat crew rescue stricken vessel du
- ·New UN report lays bare reality of human-caused cl
- ·Croydon fears summer of violence after two boys, 1
LINK
Copyright © 2011 JIN SHI